Refurb

danswankie · Post by **danswankie** » Sun Dec 19, 2010 1:31 am

Its Amazing what 3 tins of coffee will make you do

[/quote]

no its because hes been snowed in for a week

james burns · Post by **james burns** » Sun Dec 19, 2010 1:55 am

The Tetley tea bag silencer was a restoration project on its own

james burns · Post by **james burns** » Tue Dec 21, 2010 12:10 pm

PROBLEMS PROBLEMS Bloody exhaust studs, as can be seen one of the studs has sheared .
Thankfully fellow member Danswankie has a pillar drill and offered to help, so as soon as weather improves I'll be heading over where hopefully we can drill it out and retap,clean ready for new stud.

This would appear to be a common problem as I have encountered this before with these bikes . The only solution I think is plenty of high melting point grease and to take out the studs and nuts periodically and regrease.Damn and Blast this is holding things up at present and I've hidden the bike in my hallway as I've got visitors tomorrow. I'll just throw a blanket over it and disguise it as a clothes horse

bth2bth2 · Post by **bth2bth2** » Tue Dec 21, 2010 6:11 pm

as above but i have used stainless studs and nuts and washers. i also made four off spacers.

lookin good ,nice finish.

brian

Abdallah · Post by **Abdallah** » Tue Dec 21, 2010 7:02 pm

Great job man,
very neat..

Abdallah

james burns · Post by **james burns** » Thu Dec 23, 2010 7:06 pm

Success! Managed to cadge a lift and get my engine over to Danswankiies today drilled out old stud and managed to get other two out after a bit of heat.As promised Dan here is a photo of your handiwork.

Now all I got to do is clean and prepare for painting.

danswankie · Post by **danswankie** » Thu Dec 23, 2010 11:31 pm

yeah got your studs out but look what happened when i tried to get mine out of the 604 head

: Picture 008.jpg (62.83 KiB) Viewed 1364 times

at least one came out just 3 to get out

james burns · Post by **james burns** » Fri Mar 18, 2011 10:47 pm

Eventually got round to cleaning head and then sprayed with high temp matt black paint

At last engine in just to connect exhaust, carburettor and chain then try it. Will do seals as and when they start to leak.

Hope to have it running and check everything out and then Stafford here I come.
Cheers Jim.

Wirralman · Post by **Wirralman** » Sat Mar 19, 2011 8:30 pm

Well done Jim, good to see you're still sticking at it. It looks great
Eric

Post by **Bunker** » Sun Mar 20, 2011 9:34 pm

Looking triffic mate

MT Riders Club

Refurb

Re: Refurb

Re: Refurb

Re: Refurb

Re: Refurb

Re: Refurb

Re: Refurb

Re: Refurb

Re: Refurb

Re: Refurb

Re: Refurb

Who is online