Here's my MT500

jungleMTbiker

Here's my MT500

Post by jungleMTbiker » Mon Nov 04, 2013 2:29 pm

Does anybody recognise this one? It's been sitting in a shed in High Wycombe for 10 years. Previous keeper says he bought it at from a dealer in London. He's the one who painted it black, (I have mixed feelings about that--don't be surprised if it turns green again one day), and put the street tyres on it (another thing I want to change).

Image

On the other side you can see that I have already installed one of George's excellent stainless steel brake rods:

Image

as it's been sitting I need to clean out the carb (Mikuni) before I can really run it, though I have had it running enough to know that it will run. It needs to be run.
0 x

mississippimadman

Re: Here's my MT500

Post by mississippimadman » Mon Nov 04, 2013 4:54 pm

Looks cool
0 x

surfermick

Re: Here's my MT500

Post by surfermick » Mon Nov 04, 2013 9:24 pm

nice one jungle, just need to get some paint out now ;) sort it out a bit :lol:
0 x

jungleMTbiker

Re: Here's my MT500

Post by jungleMTbiker » Mon Nov 04, 2013 9:35 pm

It's not black, it's covert.
0 x

surfermick

Re: Here's my MT500

Post by surfermick » Mon Nov 04, 2013 9:45 pm

oh sorry :oops: hopei havnt blown your cover :?
0 x

jungleMTbiker

Re: Here's my MT500

Post by jungleMTbiker » Mon Nov 04, 2013 9:49 pm

The more I think about it the more I want to paint it green again. First things first, get the carby cleaned out!
0 x

jungleMTbiker

Re: Here's my MT500

Post by jungleMTbiker » Tue Nov 05, 2013 8:38 pm

It runs! I haven't figured out where to get carburettor cleaner or a fine flat-bladed screwdriver yet, so I had to go old-school and boiled the carb (with all the soft parts removed) in soapy water. That got most of the gum out of the passages. The low speed jet was still stubborn however, so I ended up holding the carb with the spigot pointing down (air filter side pointing up) and held lit matches under the area where the low speed jet screws in. Eventually I heard the gum melt out of the jet and burn up. Then it was just a matter of blowing through the jet until most of the crap drifted out. It all took less time than it sounds like it did.

Anyway, put the carb back together and installed, started it up. At least now it would run with the choke off for a little while. The road in front of the house where I am living is a private one and I had already been invited to do my test riding there, so I dropped it into gear and rode back and forth a few times--when I got back it was running ever so much better. It ticks over just fine now. Now to get that blasted paperwork sorted so I can go for a proper ride!
0 x

User avatar
Derrick
Posts: 2745
Joined: Sat Jun 27, 2009 7:47 pm
Location: Leighton Buzzard

Re: Here's my MT500

Post by Derrick » Tue Nov 05, 2013 8:56 pm

Excellent news, hope you have an easy time with the paperwork.
0 x

surfermick

Re: Here's my MT500

Post by surfermick » Wed Nov 06, 2013 7:41 am

good luck Jungle, hope that paperwork flows OK.
0 x

Post Reply

Who is online

Users browsing this forum: No registered users and 160 guests