Home made stainless exhaust

[Yoof]

Treated myself to a TIG welder recently and decided to make a full stainless system for the Armstrong.
Made the headers out of 32mm and the midsection is 50mm so a bit bigger than std.
Going for a slip on silencer.
Trying to get this done for stafford Only gave myself 4 evenings.
Any way got the hardest bit out of the way (headers and 2 into 1) Just need to sort the last bit up and round to the silencer. Like minters link pipe section.

[MT Pocket]

Spot on mate, well done. Looks great and saved loads!

[Wirralman]

Looking good Nick, well done

Eric

[ellrider]

Looking good young Nick.

Part 1 10/10

[bth2bth2]

looking great nick. be good to see it in the flesh.

brian

[rustybike]

Very nice, Nick.

[Bunker]

Lovely job mate, make sure you have the carb fitted before you bend in the cross over, or just keep it very low

[Minter]

Nice one Nick, looks good, I'll have link pipes at stafford if you need dimensions etc..

[Mr Shiney]

nice! what did you bend the pipe with?