I did ask that question! But only if i had 50 sets made!freddy54 wrote:Minter wrote:Wish i could say it was my handy work George! But it was a local exhaust place that made em! - eventually!P.I.STAKER wrote:very nice gary.
you have made a very good job of those.
regards
george
can they make s/steel ft and middle pipes up for an mt350 cheaper than the major supplier?
£280 then the VAT, cheaper to go to Force, he has plenty, my primary aim is to build the motors and supply performance enhancing mods/advice..freddy54 wrote:well is there 48 others?
what was the best price you got for 3 std but stainless pipes?
I'm sure they could Roy.. Like the bit that connects to the centre pipe.. That has been 'flared' so that it goes over the centre section.. Is your slip on of a larger diameter?Roy W wrote:Gary
could they do one with the rear section swaged out to 50mm OD ?
That's correct, the Supertrapp and the White Bros. end cans have a 50mm slip on section.Minter wrote:I'm sure they could Roy.. Like the bit that connects to the centre pipe.. That has been 'flared' so that it goes over the centre section.. Is your slip on of a larger diameter?Roy W wrote:Gary
could they do one with the rear section swaged out to 50mm OD ?
If you return it Roy i'll have the end flared to your requirements, Just let me know what diameters you'd like id od etc..Roy W wrote:That's correct, the Supertrapp and the White Bros. end cans have a 50mm slip on section.Minter wrote:I'm sure they could Roy.. Like the bit that connects to the centre pipe.. That has been 'flared' so that it goes over the centre section.. Is your slip on of a larger diameter?Roy W wrote:Gary
could they do one with the rear section swaged out to 50mm OD ?
Users browsing this forum: No registered users and 2 guests
