Page 1 of 2

Pauls Project

Posted: Fri May 07, 2010 8:45 pm
by Pwatty42
Got this bike from Withams as you can see from the pics not the best condition but Im sure I can get it looking somewhat better.

Hmmm having probs putting the pics up

will try again later

Re: Pauls Project

Posted: Sun May 09, 2010 5:41 am
by Bunker
that looks like a great project!

Re: Pauls Project

Posted: Sun May 09, 2010 7:20 am
by Apophis
that will keep you busy for the next couple of months

Re: Pauls Project

Posted: Sun May 09, 2010 8:04 am
by Wirralman
Your bike looks to have seen some service. Good luck with the refurb. Eric

Re: Pauls Project

Posted: Sun May 09, 2010 8:07 am
by Green Goblin
Hi, Ive seen a lot worse than that from Withams and owned worse. Does she run?

Re: Pauls Project

Posted: Sun May 09, 2010 8:22 am
by mtt.tr
looks kinda tidy in comparison to some other ones

Re: Pauls Project

Posted: Sun May 09, 2010 2:15 pm
by Pwatty42
Cheers, I managed to get the motor to run for a few seconds but now it is out of the frame.

The plastics are at my friends who has an Alloy wheel paint shop and the metal work is going to his mates for reworking.

I will now start on the engine, carb and electrics just need a few more bits to find so I am hoping to start the re build in two to three weeks

Heres hoping

Paul

Re: Pauls Project

Posted: Sun May 09, 2010 7:45 pm
by StackerMel
Best of luck with it Paul, looks like yours has been raced at some point, did you take off the indicators and all? Did you go to Withams to see it before you bid?

Mel

Re: Pauls Project

Posted: Mon May 10, 2010 7:07 pm
by Pwatty42
Hi I think it has been raced. It did not come with indicators, I did not see the bike before biding but got the bike for a good price so not too concerned with the condition as I have managed to get the spares I need at the right price so far.

Cheers

Paul

Re: Pauls Project Project update

Posted: Sun Jun 13, 2010 4:34 pm
by Pwatty42
Well here are some pics showing the bike in one box of bits. Carb now serviced and now moving onto engine and electrics. Powder coating will be ready next week they said. they seem a really good bunch of lads will post them on the site once i have the bike frame and bits back and check it out.