MT Riders Club

a quick pic of my new project.


dave.

oops just realised where i posted sorry admin.

What's the plan with this one then Dave?

I like the front end, however not sure about the fairing/screen affair!

Each to his own

Minter wrote:What's the plan with this one then Dave?

thought i would try to make a road/trail bike something that would tour a bit more relaxed but still be capable off road [its evolving as i build it ] up to now it has ccm upside forks, big brembo brake inc master cylinder,magura fat bars, 604 engine which by luck has a 670 cam so hopefully safe,kehin 41mm fcr carb, pro curcuit sillencer, rally raid ktm 690 dakar front and sides fairing with front light upgrade which has taken ages to fit, still lots to do
a few picks of fairing headlamp bracket design .

No offence meant I thought it was two bikes that had been put together with Photoshop to see if anyone would notice

Nice Work, What did you use to support the Fairing, it looks like you used Ply to start off then it changes to a different material, or is it ply that has been painted?

Ta,

yes arry,ply to make the patterns then plastic chopping board [read about using this on one of the adventure bike forums] as its very tough and cheap riveted together with ally angle. stainless threaded bar with plastic central heating pipe over between as its a fixed fairing the steering has less weight so less rider fatigue in theory.
dave.
hey englishman hopefully look better once all the same colour

I am sure it will. I look forward to seeing the finish job and good luck with the remainder of the project.

What an intriguing project, ill follow with interest