Dog of a MT500 pt7

Show us what you're working on (MT or very very closelyy related subjects only please).
Post Reply
Percy ingle
Posts: 11
Joined: Tue Oct 06, 2020 1:24 pm
Location: Uk

Dog of a MT500 pt7

Post by Percy ingle » Sun Nov 22, 2020 9:14 pm

Removed the clutch cover and found hard chewing gum covering a hole where some knob had put the kick start on the wrong spline and as it returned was banging into the cover! Some people need supervision with a pair of scissors let alone tools!! I have only got low heat brazing rods for aluminium and HTS2000 low heat rods are for magnesium (HTS2000 rods are made up of 9 different alloys instead of the 4 alloys in standard rods) so JB weld to the rescue again (I can always come back to it in the future) Ive got one week off to climb this restoration mountain and be on the downward slope! (Note top of engine case furrow made by bike being used with exhaust clamps missing!!
Attachments
27377C34-3FDD-4E26-9D56-9401F4B834D7.jpeg
27377C34-3FDD-4E26-9D56-9401F4B834D7.jpeg (32.04 KiB) Viewed 1052 times
4F81A897-F304-4103-8103-96F884FA8312.jpeg
4F81A897-F304-4103-8103-96F884FA8312.jpeg (28.33 KiB) Viewed 1052 times
C55905BF-F523-45B4-BFA6-0CA8CA80B063.jpeg
C55905BF-F523-45B4-BFA6-0CA8CA80B063.jpeg (28.74 KiB) Viewed 1052 times
1 x

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests